Contact

    Chengdu Huibao Energy Technology Co., Ltd.
  • Contact :Mr.Li
  • Tel:028-82213905
  • Mobile:13980030203
  • Fax:028-82213905
  • Email:lizh6688@163.com
  • Website:en.cdhbjn.com
  • Address:Economic Development Zone , Chengdu City , Sichuan Province , Chongzhou innovation Lixing Avenue home of C49

Sichuan single face colored steel phenolic board首页 > Single side color steel phenolic wind pipe plate > Sichuan single face colored steel phenolic board

productname:

Sichuan single face colored steel phenolic board

productcodee:
Product introduction:

For the connection of the flange with one-sided color steel phenolic board insert, first check that the end face of the air duct should be vertical, if there is any uneven or non vertical part, first

tag:

Sichuan,single,face,colored,steel,phenolic,board,

begintime:

2020-04-03 16:02:56

Source:

http://en.cdhbjn.com/product534899.html

For the connection of the flange with one-sided color steel phenolic board insert, first check that the end face of the air duct should be vertical, if there is any uneven or non vertical part, first correct it, then select the appropriate air duct connector, check that the quality of the air duct connector is not damaged, use the profile cutter to cut the material, and the cutting size is smaller than the inner size of the air duct by 2 to 4mm, apply glue to the section and side surface of the air duct port, apply glue to the corner gasket, place it at the proper position of the four corners of the end face of the air duct and stick it firmly, apply glue to the bonding part of the air duct connector, when the glue is not stuck, insert the air duct connector into the air duct port, with the short side facing in, compact it and hammer it with a wooden hammer; insert a worker between the connectors of the two air ducts to be connected The two straight air ducts shall be connected with a "V" type insert; the two connected air duct connectors shall be sealed with sealant first, and then the angle cover plate of the air duct shall be inserted.

The connection of H-type, F-type and U-type air duct flange of Sichuan single color steel phenolic plate

According to the needs of connecting the air duct parts, select the appropriate shape of the air duct flange, cut the two ends of the air duct flange into 45 ° angle with the profile cutter, and the length of the short side is less than 2 to 4mm of the inner side of the air duct; use the adhesive to stick the corner gasket on the four corners of the air duct, and use the adhesive to stick the appropriate air duct flange on the air duct, and seal the inner seam with the sealant.

028-82213905
hotlines for national customer service

Address:Economic Development Zone , Chengdu City , Sichuan Province , Chongzhou innovation Lixing Avenue home of C49